IRON
We have already stated the importance
of iron in our modern life. It can not be overestimated.
All the many articles of iron and steel, our tools,
our machinery, our vehicles, our bridges, our steel
buildings, and a thousand and one other things are
dependent on our iron supply.
Of all the elements that make up the
earth’s surface only three are more plentiful
than iron, so that we might think that we should always
have an abundant supply of it; but when it occurs
in small quantities, as is usually the case, it can
not of course be profitably mined. It is only
when enough of it is found together to permit it to
be mined to advantage that it is called iron ore.
Iron ore is found in only twenty-nine
states of the Union, and eighty per cent. of the present
production is in two states, Minnesota and Michigan.
We can see that iron is very unevenly distributed,
and it is on a few regions that we must depend for
all the future.
Before we can calculate how much iron
we have we must understand that it is not found in
pure form, but mixed with various other substances:
clay, shale, slate, quartz, sulphur, phosphorus, etc.
These must all be removed, some by washing, but most
of them by roasting, or “smelting,” in
blast furnaces, after which it is called pig iron.
This of course requires large quantities of fuel.
It is these things and also the position
of the ore that must be taken into consideration in
estimating the amount of iron in the country.
If ore yields a large per cent. of iron in smelting,
with a small amount of waste, it is, of course, far
more valuable than if the amount of iron in every
ton of material taken from the ground is small.
In all minerals, the relation of supply
to price is marked. The cost of labor and of
power is exactly the same whether ore yields fifty-five
tons of pure iron to the hundred, or whether it yields
only thirty tons, but the price received is little
more than half.
So if the price is low, it may cost
more to mine and smelt the one hundred tons of earth
than will be paid for the thirty tons of iron that
the low-grade ore would yield. So the lands that
produce only thirty tons to the hundred will never
be mined till the price of iron is so high that it
is above the cost of producing that is,
till it can be worked at a profit.
The Lake Superior iron found in Minnesota
is usually more than fifty-five per cent. pure iron.
That is, if a hundred tons of earth be mined, more
than fifty-five tons of pure iron would be obtained
from it. This is the highest grade of ore.
Some ore is mined that yields only forty tons or less.
There are vast quantities, billions of tons, of iron
ore in the United States, that would yield less than
thirty tons of iron to the hundred. These low-grade
ores and the ones known to lie so deep in the earth
that the cost of mining them is more than the finished
products of iron, are classed as “not available,”
that is, they can never be profitably mined under
present conditions. But we must remember that
as the higher grade ores are exhausted it will become
necessary to use the lower grades, and that prices
will steadily advance as a result.
Iron is sometimes found almost directly
under the ground, at other times deep in the earth.
That which is found just below the surface is, of
course, mined much more easily, more safely, more cheaply,
and with far less loss than that which requires deep
mining. Such conditions are found in the Lake
Superior region, and there is almost no loss at all,
the low-grade ores being piled up at one side where
they can be easily reached in case of need.
On the other hand some iron mines
now in operation are as much as two thousand feet
in depth. In these mines, as in coal mines, pillars
are left to support the rock above. A roof of
the iron ore is often left also. The low-grade
ore is left in the ground and no effort is made to
preserve it for future use. These constitute the
principal waste in iron mining.
The pure iron of the ore is separated
by washing out the clays and soft elements, but the
harder substances must be smelted by means of heat.
In the beginning this was done by charcoal, which
is still used in Sweden. The latest method is
to employ electricity manufactured by water-power,
but most of the iron smelting in this country has been
done by coal. Every ton of iron smelted requires
its portion of coal for firing. If low-grade
fuels in gas-producer engines, or water-power can be
used it will be a great aid in conserving coal.
If a limited supply of rather low-grade
iron exists near a coal region, it can often be mined
profitably, when, if it be far from an abundant fuel
supply, it must be shipped to distant blast furnaces.
The cost of shipping causes ore containing a small
percentage of iron to be classed as “not available.”
Sometimes a large company with many
mines has several varieties of ore of different strength
and hardness. If these can be mixed to produce
a medium grade by adding a small amount of high-grade
ore to a large amount of lower grade, the value of
the product will be doubled.
Sometimes, too, the by-products can
be made extremely profitable by manufacturing large
amounts when the expense of undertaking the work is
too great to be attempted with a small amount.
So if iron mines are owned by a small company much
ore may be classed as “not available” that
could be used by a large company. All these things
must be considered in estimating the iron resources.
The first smelting of iron ore in
this country was done at Lynn, Massachusetts, in 1645,
using the low-grade bog-ores and smelting with charcoal
from the surrounding forest.
Now if we look over an iron map of
the United States we shall find that there are four
hundred and eighty blast furnaces, but that only nine
of them are west of the Mississippi River and most
of these are in Missouri. The greatest of all
the iron regions now lies in upper Michigan and Minnesota.
This furnishes eighty tons out of every one hundred
mined in the United States, but the smelting is done
along the southern shores of Lake Michigan. The
reason for this is that the iron region itself is
far distant from a cheap fuel supply. Pittsburg,
Pennsylvania, has been the great iron city of the United
States on account of its nearness to great supplies
of both coal and iron. Birmingham, Alabama, is
the heart of the great smelting region of the South.
The iron is divided into districts as follows:
(1) The Northeastern, comprising the
states of Vermont, Massachusetts, Connecticut, New
York, New Jersey, Pennsylvania, Maryland, and Ohio,
supplies a little more than five per cent. of the iron
mined in the United States.
(2) The Southeastern, containing Virginia,
West Virginia, eastern Kentucky, and Tennessee, North
and South Carolina, Georgia, and Alabama, gives us
twelve per cent. of our iron.
(3) The Lake Superior district, containing
the northern parts of Michigan, Minnesota and Wisconsin,
supplies more than eighty per cent.
(4) The Mississippi Valley district
contains western Kentucky, and Tennessee, Iowa, Missouri,
Arkansas and Texas. This region furnishes less
than half of one per cent. of the total supply.
(5) The Rocky Mountain district contains
Montana, Idaho, Wyoming, Colorado, Utah, Nevada, New
Mexico, Arizona, western Texas, Washington, Oregon
and California; and all this great region now supplies
but a little more than one per cent.
The official report, which is as thorough
as can be made but is naturally subject to mistakes,
gives the amount of available iron, that is, that
which can be mined under present conditions, as nearly
five billion tons.
Let us see how long this may be expected
to supply the demand.
Before 1810 the amount of iron ore
produced was so small as to be scarcely worth considering.
From 1810 to 1870 a little less than fifty million
tons were mined, from 1870 to 1889 nearly 154,000,000
tons, and from 1889 to 1907, 475,000,000 tons, or
altogether nearly 680,000,000 tons. The production
has been found to double itself about every nine years.
In 1907 alone it was 52,000,000 tons or about one-thirteenth
of all that has been mined.
In 1880 we used 200 pounds of pig-iron
for every man, woman, and child in the country; in
1890, 320 pounds; in 1900, 390 pounds, and in 1907,
696 pounds. According to the rule of increase,
by 1916 we shall be using 104,000,000 tons a year;
by 1925, 208,000,000, and by 1934, 416,000,000 tons,
and if the same rate of increase should continue, by
1940 we should have required for our use in the meantime,
six billion tons. But we have less than five
billion tons of what is now classed as available ore,
which means that before that time (when the school-boys
of to-day are business men) we should have exhausted
all our good and cheap ore, and be obliged to depend
only on the low-grade ores, the cost of which will
be very great.
Unlike coal, the forests, and the
soil, there is no great and entirely useless waste
of iron. But the uses of iron are so many and
so varied, and the supply of high-grade ores which
can be cheaply mined is so small in proportion to
the needs of the future, that we should in all ways
lessen the drain on it by substituting other cheaper
and more plentiful materials when possible.
The chief use of iron is for the carrying
of freight. Here are some figures given by Mr.
Carnegie. Moving one thousand tons of freight
by rail requires an eighty-ton locomotive and twenty-five
twenty-ton steel cars, or five hundred and eighty
tons of iron and steel to draw it over say
an average of ten miles of double track with switches,
frogs, spikes, etc., which will weigh more than
four hundred tons. Thus we see that to move a
thousand tons of freight requires the use of an equal
weight of iron. The same freight may be moved
by water by means of from one hundred to two hundred
and fifty tons of metal, so that if freight were sent
by water instead of by rail the amount of iron needed
for this service would be reduced at least three-fourths,
the amount of coal would be reduced not less than
half, and at the same time the coal used in extra
smelting would be saved. No single step open to
us to-day would do more to check the drain on both
iron and coal than the use of our rivers for carrying
heavy freight.
The next great use of iron is for
buildings and bridges. The greatly increasing
use of cement and concrete is reducing this and will
reduce it still further. Cement is made from
slag, or the refuse of iron ore the clays
and shales and the cost of this valuable
product is little more than the former cost of piling
it away. By making the useless slag into cement
the cost of iron production is lowered and at the
same time the drain on the iron is lessened.
A large use of steel of the highest
quality is for battleships, cannon, and war supplies.
If the great nations of the world would agree to reduce
their armament, one of the great drains on the world’s
iron, coal, and wood supply would cease, and these
materials be put to improving the world.
The worst feature of it is that these
war supplies are continually changing. They must
be of the latest pattern, or they are of small value
for fighting purposes. The construction of battleships
differs greatly year by year, and the older ships
are discarded to make place for newer and larger ones.
It is said that our newest battleship alone could with
a few shots destroy all of Admiral Dewey’s fleet.
The following is from a recent magazine article:
“It is admitted by naval officers
that the ships of ten years ago are of obsolete type
and would be useless against the new vessels.
It is admitted that within ten years or less the new
types will in turn become obsolete, and will be useless
against the type of vessel certain to be evolved.
That is, as soon as a vessel costing millions of dollars
leaves the docks, she enters into active competition
for a place on the junk pile.”
The greatest improvement that can
be imagined in the iron situation will be in the discovery
and use of alloys or mixtures of iron with other materials.
Steel, the strongest of all forms of iron, is an alloy
of iron and carbon, and for various purposes these
are further mixed with nickel and silicas. Many
other alloys have been discovered within the last
few years, and each makes possible new uses for iron
requiring greater strength. One of the best of
these is a mixture of iron and silicon, called ferro-silicon.
Silica is one of the cheapest and most abundant materials
of all the earth’s products, so its combination
with iron will greatly lengthen the life of the iron
supply; and it is probable that in the future combinations
of other materials will yield better and cheaper metals
than any thus far produced.
The amount of metal which can be reworked
is constantly increasing. Most of the iron factories
remelt large quantities of old iron, to be used with
the new, and this will lessen each year the demand
on the ores. It is also possible that new deposits
of iron ore will be found and these will greatly increase
the supply. But from the whole iron situation
we may draw the following conclusions:
First, the amount of iron remaining
in the ground is very uncertain. It may be more,
or it may be less, than the present estimate.
Second, if the estimates are nearly
correct, and if the present rate of increase continues,
all the high-grade ores will be exhausted by the time
the small boys of to-day are the business men of the
nation.
Third, the best methods of reducing
the drain on the supply are, (a) The use of old iron
as a mixture; (b) Carrying a part of the freight by
water to reduce the amount of iron required by the
railroads; (c) The larger use of concrete and cement
to take the place of steel in buildings; (d) Lessening
the amount used for war; (e) The use of alloys.
This opens a large and promising field for invention.
(f) More care in preserving articles made of iron.
This is a practical thing for every person in our
country to do. Every farm implement, or tool,
that stands out in the rain or is left without shelter
during the winter, every article carelessly lost or
broken, has its part in making conditions worse.
All that are well cared for help to make the iron supply
last a little longer.